Violectric HPA V281 Service Manual download pdf (Page 22)

PLEASE NOTE:

It is generally possible to use the unbalanced and balanced outputs

simultaneously, but slight sound deterioration might occur depending on

the following devices connected. In order to ensure optimal sound

quality, only one output type should be made use of at a time.

Switching between “Pre“ and “Post“

is effected via software:

Press and hold the “LINE“ pushbutton

for about two seconds until the green

LED starts flashing. The present status

is displayed by the “XLR” LED (pre

fader) or the “DIG” LED (post fader).

The setting can be altered now by

pressing the corresponding button. To

complete the setting procedure, just

press and hold the “LINE” button again

until the green LED stops flashing.

LINE-OUTPUT LEVEL

can be set by means of internal DIP switches located on the line-out

circuit board. See page 33 for further details.

Generally, the level at the unbalanced output will equal the input level in

pre-fader mode, or with the level control set fully clockwise in post-fader

mode. By means of the DIP switches however, relative attenuation/gain

can be set to –12, -6, 0, +6 or +12 dB.

Please note that output level at the balanced output is generally +6 dB

higher than at the unbalanced output.

THE “MUTE“ FUNCTION

serves to mute ALL outputs. On the V281, it can only be activated via

remote control.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

No comments

Violectric HPA V281 Service Manual Page 22